Windows XP shutdown settings let the system reborn

boot acceleration, shutdown also acceleration. Windows XP has prepared a shortcut for fast switching, which is standby and hibernation. Let's share it today and how to use these two commands skillfully.

First, the shutdown acceleration one-button standby

Open the "Control Panel" → "Power Options", select the "Advanced" tab, here set "When the computer power button is pressed" pull down Menu, where you can select “sleep” or “standby”. Once the settings are applied, you can use one-click standby. For example, before work, there is a work to be continued tomorrow. Just press the power button on the chassis and you can leave work. The next day, press the power button to quickly enter the system and continue the work that was not completed yesterday.
When recovering from standby, you may be sneaked into the data on your computer. In this regard, in the "Advanced" tab, check the "Require password when the computer resumes from standby" item, add a security protection for standby.

Second, create a "Sleep" sleep button

First in the "Power Options" dialog box, the "Hibernate" tab, check the "Enable hibernation" function. Then right click on the desktop, select "New" → "Shortcut" in the pop-up menu, enter "rundll32.exepowrprof.dll, SetSuspendState" command in the "Create Shortcut" dialog box. Click Next to enter Hibernate in the Select Program Title dialog. After “Complete”, right click on the “Hibernate” shortcut on the desktop, open the dialog box and select the “Shortcut” tab. In the “Shortcut”, press your favorite shortcut key, such as “F8”. Once set, simply press the “F8” button to achieve one-button sleep. This article comes from www.45it.com

Third, reasonable setting of standby power

Many times, just leave the computer temporarily, then there is no need to turn off the power of most hardware devices, such as USB interface , network card, mouse and other equipment, so that the recovery speed can be improved.

Take the network card as an example, open the “Device Manager”, right click on the NIC project, and select “Properties” command in the pop-up menu to open the property setting dialog box. Select the "Power Management" tab and uncheck the "Allow the computer to turn off this device to save power" option. Click Apply. Use the same method to disable the power off function of devices such as USB and mouse.

Fourth, the standby state can also turn off the power

Normal standby method can not turn off the power, because the data is stored in the memory, once shut down, it will cause data loss. To shut down, only sleep is used, but sleep starts longer. If you use the STR technology of the motherboard power supply, you can turn off the power while in standby, and it takes only a few seconds to restore the computer to work.
Most motherboards support STR technology. Take the Soyuz SY-I5PRLE motherboard as an example. After booting, go to the CMOS settings page and select the “PowerManagementSetup” power management setting. After entering, find the "ACPISuspendType" item, set it to "S3 (STR)" mode, and save the CMOS settings. When the standby is used in the future, the power of the chassis will be automatically turned off. When the power button of the chassis is pressed, the system can be restored to the saved state during standby at high speed.

When using STR technology for standby, do not cut off the power supply of the motherboard, otherwise the saved data will be lost. In addition, to wake up the system with the mouse and keyboard in the standby state, you can set it in CMOS and set "PS/SKB/MSWakeupFromS3-S5" to "Enable".