The Volume is dirty solution

There is a problem with the computer D disk, always blue screen, and then restart the detection of the D disk, reported: The Volume is dirty.

Check the solution on the Internet.

1) Under "Start"-->"Run" type: cmd, enter msdos, use fsutil dirty query d: to check the d drive, report: The Volume is dirty. Then type CHKNTFS /XD: Report the disk partition NTFS. Then run this command directly at the run, and found no effect.

2) Restart the computer, the computer software and hardware application network (http://www.45it.com) found the previous 3 stages to check, and now it becomes 5 stages.

3) After ten minutes of testing, enter the system. The same method into the msdos, type Chkdsk /f /rd:, will prompt you: whether to remove all the handles, select Y, then divide the 5 stages to detect the d disk (due to the absence of the handle, the D disk in the check process Something can't be used), after using the fsutil dirty query d: to test the results: no damage. The repair was successful.

4) Restart and find the system is good.

The English program is attached to the back:

what you're experiencing is what Windows refers to as "setting the dirty bit" and what you have to do is unset that bit. Every time Windows XP starts, autochk.exe is called by the kernel to scan all volumes to check if the volume dirty bit is set. If the dirty bit is set, autochk performs an immediate chkdsk /f on that volume. Chkdsk /f verifies file system integrity And attempts to fix any problems with the volume. It is usually caused by a hard shut down or a power loss during a read-right operation on that particular drive.

How do I fix it, you ask?< Br>

Well, that's easy. First click Start> Run> bring up a command prompt by typing in "CMD" and type "fsutil dirty query d: ". This queries the drive, and more than likely it will tell you Next, type "CHKNTFS /XD:". The X tells Windows to NOT check that particular drive on the next reboot. At this time, manually reboot your computer, it should not do a Chkdsk a Nd take you directly to Windows.

Once Windows has fully loaded, bring up another CMD prompt and type and now you want to do a Chkdsk manually by typing "Chkdsk /f /rd:". This should take you Through 5 stages of the scan and will unset that dirty bit. Finally, type "fsutil dirty query d:" and Windows will confirm that the dirty bit is not set on that drive.