Press F1 to boot into the system to cancel the method

To press F1 to start: There are several reasons: 1. The CMOS parameter setting is incorrect: Floppy drive: No floppy drive is detected, please check if the data cable is connected, then look at the BIOS. The setting in the pair is not: check the setting of the boot sequence; in addition, if there is no floppy drive directly shielded. STANDARD CMOS → Drive A: None

Keyboard: Some keyboard problems in CMOS settings will also appear to press F1 to boot, the landlord check it yourself. Memory: disable memory check try 2, BIOS battery low battery prompts - replace the battery

3, jumper settings - refer to the manual settings. 4, the network card MAC address is not legal: there will be prompt mac Address are invalid in both apc and dmi press F1 to resume Another possible hardware error is not fatal, you can replace the check